Waxahachie, Texas
Drywall Materials Guide for Waxahachie Homeowners
Knowing what goes into a repair makes a plan easy to follow. Here is what we use, and why.
Board types
Standard half-inch board is common on walls. Ceilings are often thicker or sag-resistant, because a thin board hangs under its own weight between framing members. Five-eighths board is stiffer and often used where more rigidity helps.
Moisture-resistant board is used in rooms that see steam and splashes, such as bathrooms. It resists dampness better than standard board, though it is not waterproof, and it is not a cure for an active leak.
Which board we use for a patch depends on the thickness already in your wall. A patch has to sit flush with the wall around it, so we measure before we cut.
Joint compound
Compound is the material that fills seams and screw heads and builds the patch. There are two main families.
Setting-type compound hardens by a chemical reaction and comes in different working times. We use it for deep fills and for first coats, where we do not want to wait a full day.
Premixed compound dries by evaporation, and it sands more easily. We use lighter versions for finishing coats.
Each coat is thin and gets wider than the last, which is what lets the patch fade into the wall.
Tape
Paper tape is strong and sits in a bed of compound. It is a standard choice for seams and for cracks, and it handles the small movements that bare filler cannot.
Mesh tape is self-adhesive, and it is convenient for quick patches and for the small repair pieces used on holes. We choose by situation: where strength matters, we use paper; for fast patches on small damage, mesh can work well with the right compound.
Fasteners and corner bead
Drywall screws pull the board tight against framing. A nail pop is what happens when an old fastener backs out, and the fix is to set a screw next to it. We drive screws just below the paper surface, without breaking it.
Corner bead protects outside corners, such as the edge of a wall that sticks into a hallway. It can be bent by a bump, and we replace damaged sections rather than filling over them.
Texture and primer
Texture is the last decorative layer. Orange peel is a fine spray; knockdown is a spray that is flattened. We use a texture mix matched to what is on your walls and test it first.
Primer seals the repair. Fresh compound is thirstier than painted wall, and without primer a patch can show through paint as a dull spot.
Choosing for older and newer Waxahachie homes
Older homes near the courthouse square may have plaster or layered walls, and we choose materials that bond well to what is there. Newer subdivision homes usually have standard board, so we match its thickness and the builder's texture.
For ceilings below an attic or a roof that has leaked, we replace wet board with new board rather than patching over it, and we fasten into dry, solid framing.
Show us the wall
We will tell you which of these your wall needs.